Blue Print of Future DIY memory foam bed - comments welcome
Jul 12, 2012 11:11 PM
Joined: Jul 12, 2012
Points: 4
So I was dead set on the below blue print for a DIY memory foam mattress but after seeing Talalay Latex thrown around so much I'm wondering if it's any better? Price wise, lasting, cooler, etc     I'm around 6'1 and 160 lbs at the moment naturally skinny frame with a bad back which I believe is due to sleeping on the floor/horrible Target pillows for the last 6 years. I like the plushy/sinking in feel that the Tempurpedic Cloud Supreme has. 

 

Blue Print: 

Bottom Layer: 6inches LuxHQ from foambymail http://www.foamdistributing.com/LHQ_2/lux-hq-foam-mattress.html

Middle Layer: 4inch/4lb  Aerus topper from sleepwarehouse.com http://www.sleepwarehouse.com/aerus4lbmemoryfoammattresstopper.aspx

Top Layer: 4inch/5lb  Sensus topper from sleepwarehouse.com http://www.sleepwarehouse.com/sensus5lbmemoryfoammattresstopper.aspx

My plan is to place them on the floor until I can grab a platform bed frame from craigslist or somewhere for cheap. Now my place gets dusty and has carpet so my thinking is to wrap it in some sort of cover either individually or altogether as to avoid any stains, water damage( I eat and drink in my room and theres a cat living here) etc. The idea is to cover the foam once to protect it then again so that the sheets won't slip off (assuming the base cover is slippery) and then put sheets on that allow a cool and comfortable surface both in the winter and during the summer. 

What do you guy's think? Cheaper way? easier way? Firmer base foam?  (keep in mind my budget is limited and I'd have to buy these pieces one at a time over the course of a couple of months most likely. I'm a college student.)

Re: Blue Print of Future DIY memory foam bed - comments welcome
Reply #10 Sep 26, 2012 1:56 PM
Joined: Sep 26, 2012
Points: 1
Hi Joel -

Thanks for the great post!

I'm about to use your suggestions to build a foam mattress.  Just wanted to check if you had any updates or managed to source the top 2" layer?

Kartik

Re: Blue Print of Future DIY memory foam bed - comments welcome
Reply #11 Jan 24, 2013 7:00 PM
Joined: Jul 12, 2012
Points: 4
ksundar wrote:

Hi Joel -

 

Thanks for the great post!

I'm about to use your suggestions to build a foam mattress.  Just wanted to check if you had any updates or managed to source the top 2" layer?

Kartik

 

Kartik,

 

Depending on the ILD your looking for...The Aerus mentioned in my first post is 12ILd and the Sensus is 13ILD. There a little more expensive but worth it. There are other foams on sleepwarehouse that are lower ILD too.

 

 



Re: Blue Print of Future DIY memory foam bed - comments welcome
Reply #12 Oct 29, 2018 12:15 PM
Joined: Oct 29, 2018
Points: 1
thanks