Cutting up latex
| Is it possible to cut latex at home? I have a king layer (about 2.6") that I would like to cut in half to make 2 twins. I guess I could just take a scissors and have at it but I'm afraid that might ruin it. So, is it possible to cut this, and if so what is the recommended method? Thanks. |
Re: Cutting up latex
|
Looks like low quality latex. Possibly 100% synthetic? I have never seen the holes close up like that, but I don't have that much experience. I don't think you have much to lose at this point, but a newer higher quality piece might work better. Especially if you are saying it is compressed in some spots. This message was modified Dec 17, 2010 by sandman
|