| I see theres the option of buying your own latex layers and then putting them together to make a mattress - what do people use for the exteriors? Is this option significantly cheaper? Im trying to make something extra sustainable (as well as, of course, comfortable!) |
|
kawasakiguy37 wrote:
Anybody use a normal spring mattress (for the firm support) instead of something like the 6 inch dunlops? Im thinking I could save money here - maybe build a DIY bed with a thin innerspring and two 2" talalays on top - a firm and a soft on top, or maybe two mediums? As to the original post here in this thread, yes, you can just throw layers of latex on top of each other and put anything on top of the latex. THe latex tends not to shift much due to the friction of rubber. I even use zoned pieces cut into thirds so I can have a firmer piece in the middle for my hips and the 3 pieces hardly shift. I check them once a month or so and adjust as needed. Sometimes it's not needed. I just use a couple of sheets under my bottom sheet for protection of the latex. Is this the best protection? Probably not. But it is probably good enough. Ideally I'd say use a wool layer over your latex, maybe a thick wool blanket or comforter. Sometimes I use a wool layer but mine is too thick (2" or so) and sometimes I feel it causes my lower back to sink in too much and cause pain. This message was modified Jun 9, 2011 by jimsocal
|