|
First off thanks to all on this board. I have been looking to purchase a latex bed for quite some time now, and I almost pulled the trigger on a Sealy model that was made of (mostly) latex. Now that I know a lot more, I am getting really into the details and this forum helps me a lot. I've been looking at the split layers (one firmness side for each person) and zoned systems (head to toe firmness differences) and I am curious if any of you can share any insight. My questions are below: 1) For the different firmness for each person, the latex needs to be split into two pieces - left side and right side. Are there problems with one edge rubbing up against the other edge and creating a bump in the middle of the bed? Any other potential issues? Or does it seem to work without any issues. 2) Does having three layers (stacked on top of each other) cause any issues as well, such as shifting, rubbing, etc etc? Does it matter if I have to put the soft side on the bottom (If the exhange period is over and I need a firmer bed for instance)? 3) Does anyone have any experience with the zones (diffenrent firmness from head to toe) and is it worth it at all? Meaning is it just another gimmick or does it really make a difference. 4) Would stacking Dunlop on bottom and Talalay on top help for a larger person because Dunlop is more dense and might prevent bottoming out? This question is not for me but I maybe recommending latex for somebody. Any thoughts (regardless of if you have actual experience) would be helpful. Thanks in advance. I have alot more questions but I'll post separately. |
| Hi, thanks for the replies. I really have no idea how they construct traditional mattresses but I imagined everything was somehow sewn together/glued together. Basically I just don't want the cover to get loose and wrinkled under the sheets. I want it to stay taut. My husband will definately be unhappy about if that happens. |
| My FloBed zippered mattress cover is tight and there is no wrinkling. When I am making my bed and have the bed bare before I put on the fitted sheet, it looks like a conventional mattress to me. The original FloBed zippered mattress cover (May 2007)was not as nice but the new one sent to me a few months later has a piece that went under the area where the zipper was so that the zipper did not catch onto the latex. This new mattress cover that FloBeds has been selling since is so comfortable as well as having a snug fit with a little bit of give. The first cover has a small defect and when I called I was told to wait until the new covers came out and I finished moving my latex pieces around and then Dave would ship me a new zippered mattress cover. |