|
Anyone have recommendations for a foundation for a latex mattress that will fit into a regular bed frame? I'm looking for maximum motion suppression, minimum noise - I guess good build quality will accomplish this. A slats-only base wont work since the bed frame is only 6" off the ground and I like too add some height. Thanks! |
|
I have this bad boy: http://www.amazon.com/Handy-Living-Queen-Wood-Frame/dp/B002KQ5KQG/ref=sr_1_1?s=home-garden&ie=UTF8&qid=1304658315&sr=1-1 Didn't work that well with spring mattresses but with my latex bed it works great, and has decent clearance (13-14") for under bed storage. Plus it's silent, no squeaks or anything, possibly because most of it is wood. Biggest downside is putting it together/taking it apart when you have to move. It takes a while for each slat. |
| I probably wouldn't recommend the above foundation if its exactly as pictured. Not because it would damage the mattress but I think the type of slats (curved) used will bend significantly under weight and possibly make the mattress feel uneven, especially if it is a thinner latex mattress. |
| I'd think there would be any number of Co's that offer platform foundations that look like traditional box springs. We bought a new foundation with our latex mattress last fall. Looks, fits into a traditional bed frame just as a box springs would. Ours is covered in same material as the mattress. Offered in 2 different heights and no noticable give to it. It is supported full length along both sides by the bed frame as a box spring would. One requirement that the Co required was for a qween was the foundation needed to be supported in at least one place on the center all the way to the floor. Top surface is fairly thick slats on about 5-6" centers. Don't recall the specific cost as we bought as a set but think the cost was close to $200. |
|
budgy wrote: I probably wouldn't recommend the above foundation if its exactly as pictured. Not because it would damage the mattress but I think the type of slats (curved) used will bend significantly under weight and possibly make the mattress feel uneven, especially if it is a thinner latex mattress. |
|
That's good feedback on those adjustable frames - I had wondered about that too. Here's another slat frame option I found on amazon. Seems sturdy from the reveiws. |
|
Is there any reason that a plywood platform would not be suitable for a latex mattress? Does latex need to "breathe"? This message was modified May 11, 2011 by Phoebe2011
|
|
Check out this thread for varying opinions on the "breathing" issue, including Dewey from Flobeds (reply #8): http://www.whatsthebest-mattress.com/forum/best-foundation-latex/4679-A-1.html |
|
proof1st wrote: That's good feedback on those adjustable frames - I had wondered about that too. Here's another slat frame option I found on amazon. Seems sturdy from the reveiws. |
|
Here is the foundation we bought for our latex mattress. Make sure if you order one that you tell them you want the EZ-Sleep foundation with the nicer cover. I should mention that I went to Home Depot and purchased a couple 1" X 4" X 8' and made up 4 or 5 extra slats so I could make the space between each slat about 2 inches. http://www.bedinabox.com/product/52.html |
|
Well, the Goodrich 4" latex mattress placed on a plywood foundation that we have been sleeping on for 47 years has never had any condensation or mold problems. We have used a thin rubber pad, covered with some kind of soft material over the part of the bed where the trunks of our body were all those years. Maybe that or the fact that the latex was only 4" were the reason we had no problems. One person at Savvy Rest said that we could use a plywood foundation. Didn't ask anyone else, but will ask that question again. Thanks for all the feedback! |