|
My current mattress is about 10 years old and is probably due for repalcedment. I have a hard time sleeping sometimes, and don't always wake up refreshed. So I visited a mattress store yesterday and spent about an hour trying just about every bed in the joint. The one I liked the best was the low end Stearns & Foster in a plush. Unfortunately, it was out of my price range. The salesman brought down the price about 25% by using a "clearance" box spring, but I didn't give in. I probably would have had he thrown in free delivery. Decided to "sleep on it." I had read a little bit before going to the store, and was trying to look for stuff like the number of coils and gauge of steel. They didn't have much of that info. I tried the Tempurpedic bed and thought it was nice, but out of my price range. They had a few latex floor models for 50% off. There was one that I liked that seemed a little firmer than the rest, and I think I could have been happy with it. I liked the individual coils the best, but maybe I'm not used to latex or foam? Anyways, I got home and started researching and found that the three-S's are frowned upon and basically scratched them off! I've read through here and found recommendations to search for local mattress companies. I found a few: http://www.bowlesmattress.com/html/crown.htm http://indianamattresscompany.com/default.aspx http://www.holdermattress.com/ http://www.holderbedding.net/index.html I can get to the places that carry those beds.. Should I try to find the firmest matress I can and buy toppers? My initial thinking is a firm mattress from a local shop and getting the 2.5" memory foam topper from Sam's club - staying local in case I'm unhappy. Find the lowest gauge steel? Bonnell springs, or open? I've read about the DIY mattress.. like FBM stuff. That's not entirely unappealing. Doing surgery is unappealing though, because I'm a litle clumsy ;) I'd run in to the problem of a foundation (I have a headboard, footboard, and side rails I'd like to keep) with the DIY stuff. It's kinda scary for me to go this route since I can't try the foam or latex before I buy. I don't want to be completely stuck. I'm 6'4" and about 240.. so a big guy. I sleep on my back and side. Anyone care to poke me in a certain direction for further researching? I'm (more than) a little confused right now. |
|
Well, I'm not sure of the amount of foam on the top and bottom of the springs, but it's not much. It's a flippable mattress, 13gauge coils top and bottom, 12 3/4 in the middle. The salesman said the last one he sold was to a couple in their 80's that said they wanted a mattress one step softer than a board. I can ask how man inches of foam top and bottom when they deliver (small company, my salesman said he'd be delivering) if you're curious. I definitely did not buy it because of its comfort! |