Latex ventilation holes

[Akamic]

I received my one inch 20 ILD latex topper today. As soon as I unrolled the topper I noticed that the ventilation holes did not go through the entire depth of the foam. Is this typical, or do I have a defective piece of foam on my hands that I will need to return? I assume this will also affect the breathibility of the product, no?
Thanks again for your input.

 

[Dallasgirl]

Where did you get it from??

 

[Akamic]

I ordered the topper from foambymail. According to the customer support representative, this is not a defect and will not affect the latex. According to all the information I have read though, the holes are there for ventilation. I may just pay the return shipping and return it.

 

[weiser701]

The holes in mine go all the way through. The only imperfections appear to be from the cutting process. It's not too bad though. Probably quite acceptable for the price. I would still be a little annoyed by the outcome of your topper since all of the foam and layex I purchased from FBM appears to be as advertised.

 

[budgy]

This really is normal for this to happen. I would not be overly concerned about it.

 

[Akamic]

Thank you for the comments... Although not what I had expected, I have decided to keep topper and perhaps purchase a softer one inch layer of latex to place on top. Any suggestions?