higher ILD?
| I currently have a Flobeds posture deluxe composed of 3 layers of super firm blended talalay. The ILD is supposed to be 42-46. I am still waking up with low back pain and I am wondering if there a higher ILD out there so I can increase the firmness of the layers? Or is there another route I can go with this? Dunlop? firmer topper instead of convoluted one? Any suggestions would be appreciated. |
Re: higher ILD?
| You might also want to try just two layers of 3" latex on top of a robust foundation - all that latex might be leading to body contortions that in turn create the back pain. I'm only 108 lbs and I found M/F/F far too soft (bottom half of my body sunk all the way in but not my top half), and F/F/XF (the firmest I tried) both too firm and too soft -- too firm in that the mattress created painful pressure points, but too soft in that the mattress contorted my body out of alignment leading to major pain. Ultimately, I decided to go back to an innerspring mattress, but were I to make another try with the latex (which I prefer in theory to innerspring), I would likely try just two 3" layers, probably in Dunlop. When I put a 3" medium layer on a firm innerspring, it was almost right -- just a tad soft (3" firm was a tad firm). I found the convoluted 2" to be largely irrelevant - marginal impact on support if at all, greater impact on comfort. |
Re: higher ILD?
|
fubu04 wrote: Thank you for all the feedback. Its lower back pain. I alternate between back and my side as I sleep. Lately I have been sleeping on my side to somewhat alleviate the low back pain. I started with a vzone firm and the pain was still present. fubu04: I do not see anywhere in this thread where you indicate whether or not you originally hurt your back, or if you have a permanent bad back condition, or if the FloBeds caused the back pain. Did you have any back pain before you purchased the FloBeds? From the limited amount of information you have posted I would have to guess that your back problems could be caused by something other than the bed. I have had back problems since I was a very young man and got it hurt playing football. Over the years various things have given me problems. Now that I am older almost anything can give me some momentary pain. But normally I can work it out by doing some stretching, or having my wife rub my back with a big old vibrator that I bought many years ago. While I certainly am not a doctor nor am I wanting to prescribe medical treatment for you, you might seriously consider going to a good chiropractor for an evaluation and possibly some treatment. I know that I used one for many years and he did me a lot of good. I just have never heard of someone that only weighted 150 lb. needing this firm of the mattress unless they had something very seriously wrong with their back. I hope you get your problem worked out, as I know what persistent back pain is like. Good luck! This message was modified Feb 17, 2010 by eagle2
|
Re: higher ILD?
|
eagle2 wrote: I have a FloBeds and the almost perfect firmness levels for me are F/F/XF. And I am 6 foot two and weigh 210 pounds. How did you come to such a firm mattress? Did FloBeds recommend this to you? I would almost guess that your mattress is too firm. Remember that a firm piece of latex from FloBeds is 32 ILD. And extra firm piece is 36 ILD. Or thereabouts. Eagle, we back pain people are so very individual I don't think you can generalize. It's trial and error. I had the same configuration as you but at only 130 lbs F/F/XF is too soft for me. Fubu, it sounds like you've basically maxed out the firmness of the latex and that still isn't doing it for you. What happens to your back when you sleep directly on the floor? I do this when things get bad with my back just to get a little relief. It's not a solution since I wake up during the night with sore hips, shoulders and elbows and I don't get much sleep, but it does make my lower back happier. If you have a floor-loving back like mine you want more firmness, but if this doesn't provide relief you might want to try a different tactic. If you really do need more firmness, have you tried removing the eggcrate layer? I have my suspicions that such a thick layer of soft material may be causing me some problems. Though sleeping directly on the support layers didn't work for me. My other suggestion is that maybe you should switch one layer back to the VZone (extra firm). Since having the whole bed as firm as possible isn't working out, perhaps being able to vary the mattress strategically would increase your comfort. My VZone is currently XF under the hips and F under the shoulders, over supporting layers of F/XF, and this has been the best configuration for me so far. Linda |
Re: higher ILD?
|
Linda said: "Eagle, we back pain people are so very individual I don't think you can generalize. It's trial and error. I had the same configuration as you but at only 130 lbs F/F/XF is too soft for me." I agree that generalizations are always suspect when they are applied to human beings. We are just too variable within ourselves, and life has a way of presenting too many intervening variables. That acknowledged, I think we look to our beds far too often as the source of our difficulty. Sometimes they are, sometimes they may contribute to the problem and exacerbate it, sometimes they are actually helping the problem from becoming worse, and yet we still blame the bed. For instance. I currently am suffering through some hip pain. But the hip pain has not been caused by my bed. It was caused by doing a job around the house where I had to do a lot of positioning myself very low and I stretched out some ligaments or something in the hip area. This is a case where only time and the proper stretching exercises are going to cure it. But my bed, depending on its firmness layers, can either hasten the healing process, if it is properly configured, or slow down the healing process if it's not properly configured. But we have to be able to tell the difference. I changed my mattress configuration yesterday to a firmer configuration. This has helped, it seems to me. Another thing that needs to be seriously considered is the foundation on which the mattress sets. If the foundation is not solid enough it will flex giving you misreadings on your mattress configuration ( here we're talking about latex mattresses that are configurable). One thing that could be done would be to put the mattress on the floor, if the floor is very solid. My home is built on a concrete slab so that would make the perfect foundation for a mattress if I'm trying to ascertain the proper firmness levels for the mattress. But if I had the kind of an ongoing problem with my lower back that fubu04 has I would be talking to a good chiropractor or osteopathic doctor (A DO not an MD). This message was modified Feb 20, 2010 by eagle2
|
Re: higher ILD?
|
Eagle, you make so much sense it is scarey. I think the reason for my pain is sitting in a contour (not flat) shaped chair that hurts my hips all day, it pushes the hips up and hurts your bursa and nerves. I found a website that explains sitting on a flat chair is better for your hips than a contoured shape chair. These ergonomic chairs now days do more damage for the hips than help. I also use my back to do things instead of squatting at the knees due to torn meniscus and hip problems, so that explains my back pain. You are so wise. I am not going to make anymore changes to my mattress until I get my day pain in check. This message was modified Feb 20, 2010 by Leo3
|
Re: higher ILD?
|
Leo: Thank you for your kind words. Everyone likes to hear praise, but for some reason, it gets sweeter as we get older. I'm going to post a link to a post made by Kate, here, http://www.whatsthebest-mattress.com/forum/discouraged-does-latex-break-lot-after-week-two/9420-0-1.html. It is post #14 placed today. She gives a very important and detailed response to the very question of "What can be causing our back pain besides our beds?" Here is a woman who has spent a great deal of money, and put a great deal of thought, into correcting her back pain besides constantly changing the configuration of her mattress. She realizes that there are many things we do besides spend eight hours a night on our mattress that can be causing, or at least contributing to, our back pain. There are many, many, many reasons for back and neck pain. The ancient Greek physicians utilize something that doctors need to return to in our modern day and age of endless tests whether that be by blood, x-ray, or you name it. They ask their patients a series of important questions. The first one being "What you do to make a living?" In other words what kind of exposure does your body have to stress on a daily basis. They knew that most of our maladies came from our exposure to physical stresses. We all know that you have to have the proper mattress, to not only get a good nights sleep, but to live a healthy lifestyle. But when we have examined the minutia of our current configuration and are still having problems, the common sense thing to do is, look elsewhere for what might be causing the difficulty. Many times commonsense thinking(combined with judicious investigation of the Internet) can possibly do more for us than all the doctors in the world. This message was modified Feb 20, 2010 by eagle2
|